YAW RATE AND DECELERATION SENSOR(for 4WD/AWD without VSC) REMOVAL

PROCEDURE


  1. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  3. REMOVE FRONT SEAT ASSEMBLY LH


    1. for Manual Seat:

      Click here

    2. for Power Seat:

      Click here

  4. REMOVE FRONT DOOR SCUFF PLATE LH

    Click here

  5. REMOVE YAW RATE SENSOR BRACKET


    1. A01KB68

      Remove the bolt and yaw rate sensor bracket.

  6. REMOVE DECELERATION SENSOR


    1. A01KAQ4

      Disconnect the deceleration sensor connector.

    2. Remove the 2 bolts and deceleration sensor.

      Note

      Do not remove the sensor from the bracket.