REAR SPEED SENSOR(for 4WD/AWD) INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedures listed below are for the LH side.

PROCEDURE


  1. INSTALL REAR SPEED SENSOR LH

    Note

    To prevent interference with other parts, do not twist the sensor wire's painted line areas when installing it.


    1. A01QU21E02

      Install the sensor labeled A with the bolt labeled B.

      Torque:
      8.5 N*m  { 87 kgf*cm, 75 in.*lbf }

      Note


      • Keep the sensor tip and sensor installation hole free from foreign matter.

      • To prevent interference with the bearing rotor, do not rotate the sensor body when inserting the sensor body or after inserting the sensor body.

    2. Install the sensor clamp labeled C with the nut labeled D.

      Torque:
      5.0 N*m  { 51 kgf*cm, 44 in.*lbf }
    3. A01QRI0C01
      *a Painted Line

      Install the sensor clamps labeled E with the 2 nuts labeled F.

      Torque:
      5.0 N*m  { 51 kgf*cm, 44 in.*lbf }

      Note

      Do not twist the sensor wire when installing the clamps.

    4. Install the sensor clamp labeled G with the bolt labeled H.

      Torque:
      8.5 N*m  { 87 kgf*cm, 75 in.*lbf }

      Note

      Do not twist the sensor wire when installing the clamp.

    5. A01QQ8UC02
      *1 Grommet
      *2 Connector
      *3 Band Clamp
      *a Inside of Vehicle

      Insert the connector and grommet to the inside of the vehicle through the passage hole in the wheel house.

      Note

      Make sure the grommet band clamp remains on the outside of the vehicle.

    6. Hold the grommet and pull it from the inside of the vehicle to the outside of the vehicle. Then fix it in place so that it is not tilted.

      A01QPUYC03
      *a Outside of Vehicle *b 30°

      Note


      • When pulling out the grommet, do not grip the sensor wire.

      • Fix the grommet in place within the range shown in the illustration.

    7. Connect the speed sensor connector.

  2. INSTALL DECK TRIM SIDE PANEL ASSEMBLY LH

    Click here

    Tech Tips

    Refer to the procedures from the installation of the deck trim side panel LH up until the installation of the rear door scuff plate LH.

  3. INSTALL REAR WHEEL

    Torque:
    103 N*m  { 1050 kgf*cm, 76 ft.*lbf }

  4. CHECK SPEED SENSOR SIGNAL

    Click here