REAR SPEED SENSOR(for 4WD/AWD) REMOVAL

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. REMOVE REAR WHEEL

  2. REMOVE DECK TRIM SIDE PANEL ASSEMBLY LH


    1. Remove the deck trim side panel LH Click here.

      Tech Tips

      Refer to the procedures from the removal of the rear door scuff plate LH up until the removal of the deck trim side panel assembly LH.

  3. REMOVE REAR SPEED SENSOR LH


    1. A01QO64

      Disconnect the speed sensor connector.

    2. A01QQQC

      Disconnect the grommet of the speed sensor wire from the hole of the wheel house.

    3. A01QRI0E01

      Remove the bolt labeled A and sensor clamp labeled B from the side member.

    4. Remove the 2 nuts labeled C and sensor clamps labeled D from the upper arm.

    5. A01QU21E01

      Remove the nut labeled E and sensor clamp labeled F from the trailing arm.

    6. Remove the bolt labeled G and sensor body labeled H from the carrier.

      Note

      Keep the sensor tip and sensor installation hole free from foreign matter.