REAR SPEED SENSOR(for 2WD) REMOVAL

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedures listed below are for the LH side.

PROCEDURE


  1. REMOVE REAR WHEEL

  2. REMOVE DECK TRIM SIDE PANEL ASSEMBLY LH


    1. Remove the deck trim side panel LH Click here.

      Tech Tips

      Refer to the procedures from the removal of the rear door scuff plate LH up until the removal of the deck trim side panel LH.

  3. REMOVE SKID CONTROL SENSOR WIRE


    1. A01VAGG

      Disconnect the skid control sensor wire connector.

    2. A01V8OI

      Disconnect the grommet of the skid control sensor wire from the hole of the wheel house.

    3. A01V9ZP

      Remove the bolt and sensor clamp from the side member.

    4. Remove the 2 nuts and 2 sensor clamps from the upper arm.

    5. A01V9YD

      Remove the bolt and sensor clamp from the carrier.

    6. Disconnect the skid control sensor wire connector from the skid control sensor.

  4. REMOVE REAR DISC BRAKE CYLINDER MOUNTING LH

    Click here

  5. REMOVE REAR DISC

    Click here

  6. REMOVE REAR AXLE HUB AND BEARING ASSEMBLY LH (SKID CONTROL SENSOR)

    Click here