REAR UPPER ARM REMOVAL

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. REMOVE REAR WHEEL

  2. DISCONNECT SKID CONTROL SENSOR WIRE LH


    1. A00YTYT

      Remove the 2 nuts and disconnect the skid control sensor wire from the rear upper control arm.

  3. REMOVE REAR UPPER CONTROL ARM ASSEMBLY LH

    A00YTTA

    1. Using a jack and wooden block, raise the vehicle and hold the rear No. 2 suspension arm assembly LH together with the rear axle carrier at the standard vehicle height.

    2. A00YS7Q

      Remove the 2 bolts, 2 nuts and upper control arm.

      Note

      Since a stopper nut is used, remove the bolt.