DIFFERENTIAL MOUNT CUSHION INSTALLATION

PROCEDURE


  1. INSTALL REAR NO. 1 DIFFERENTIAL MOUNT CUSHION


    1. Using SST, install a new rear No. 1 differential mount cushion.

      SST
      09316-12010
      A01QQGJC02
      *1 Rear Suspension Member Sub-assembly - -
      *a 0° +/- 3° *b 5.0 to 6.0 mm (0.197 to 0.236 in.)
      A01QOU0 Front of Vehicle - -

      Note


      • Make sure that the differential mount cushion is aligned within 3° from the center.

      • Be sure to use the correct combination of SST.

      • Before using SST, apply grease to SST bolt.

      • Temporarily install the rear No. 1 differential mount cushion to the rear suspension member sub-assembly in order to prevent it from tilting, and then install SST.

      • Make sure that SST contacts the entire circumference of the rear No. 1 differential mount cushion.

      • Do not tilt the bolts of SST.

  2. INSTALL REAR SUSPENSION MEMBER SUB-ASSEMBLY

    Click here

  3. INSTALL REAR DIFFERENTIAL CARRIER SUB-ASSEMBLY

    Click here

  4. INSTALL REAR DIFFERENTIAL DYNAMIC DAMPER LH


    1. Install the rear differential dynamic damper LH (front side) with the 2 bolts to the rear No. 1 differential support.

      Torque:
      39 N*m  { 398 kgf*cm, 29 ft.*lbf }

  5. INSTALL REAR DIFFERENTIAL DYNAMIC DAMPER RH


    1. Install the rear differential dynamic damper RH (front side) with the 2 bolts to the rear No. 2 differential support.

      Torque:
      39 N*m  { 398 kgf*cm, 29 ft.*lbf }