REAR AXLE HUB ON-VEHICLE INSPECTION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. REMOVE REAR WHEEL

  2. DISCONNECT REAR DISC BRAKE CALIPER ASSEMBLY LH

    Click here

  3. REMOVE REAR DISC

    Click here

  4. INSPECT REAR AXLE HUB BEARING LOOSENESS


    1. A01V6TN

      Using a dial indicator, check for looseness near the center of the axle hub.

      Maximum
      0.05 mm (0.00197 in.)

      Note

      Make sure that the dial indicator is set perpendicular to the measurement surface.

      If the looseness is more than the maximum, replace the axle hub assembly.

  5. INSPECT REAR AXLE HUB RUNOUT


    1. A01V7F1

      Using a dial indicator, check for runout on the surface of the axle hub inside the rear axle hub bolt.

      Maximum
      for 2WD: 0.08 mm (0.00315 in.)
      for 4WD/AWD: 0.06 mm (0.00236 in.)

      Note

      Make sure that the dial indicator is set perpendicular to the measurement surface.

      If the looseness is more than the maximum, replace the axle hub assembly.

  6. INSTALL REAR DISC

    Click here

  7. CONNECT REAR DISC BRAKE CALIPER ASSEMBLY LH

    Click here

  8. INSPECT AND ADJUST PARKING BRAKE

    Click here

  9. INSTALL REAR WHEEL

    Torque:
    103 N*m  { 1050 kgf*cm, 76 ft.*lbf }