REAR AXLE HUB INSTALLATION

CAUTION / NOTICE / HINT

PROCEDURE

1. INSTALL REAR AXLE HUB AND BEARING ASSEMBLY LH (for 2WD)

   
   

   1. Install the rear axle hub and bearing assembly with the 4 bolts.

      Torque:

      90 N*m  { 918 kgf*cm, 66 ft.*lbf }

2. INSTALL REAR AXLE HUB AND BEARING ASSEMBLY LH (for 4WD/AWD)

   
   

   1. Align the shaft splines and drive shaft to the axle hub and bearing assembly.

   2. Install the axle hub and bearing to the rear axle carrier with the 4 bolts.

      Torque:

      90 N*m  { 918 kgf*cm, 66 ft.*lbf }

      Note

      Be careful not to damage the drive shaft boot and speed sensor rotor.

3. INSTALL REAR AXLE SHAFT NUT LH (for 4WD/AWD)

   
   

   1. Clean the threaded parts on the drive shaft and a new axle shaft nut using a non-residue solvent.

      Note

      
      

      • Be sure to perform this work for a new drive shaft.

      • Keep the threaded parts free of oil and foreign objects.

   2. Using a 30 mm socket wrench, temporarily install a new axle shaft nut.

      Torque:

      216 N*m  { 2203 kgf*cm, 159 ft.*lbf }

      Tech Tips

      Stake the nut after inspecting for looseness and runout in the following steps.

4. INSPECT REAR AXLE HUB BEARING LOOSENESS

   Click here

5. INSPECT REAR AXLE HUB RUNOUT

   Click here

6. CONNECT SKID CONTROL SENSOR WIRE (for 2WD)

   
   

   1. Connect the connector.

7. CONNECT REAR SPEED SENSOR LH (for 4WD/AWD)

   
   

   1. Install the rear speed sensor to the rear axle carrier with the bolt.

      Torque:

      8.5 N*m  { 87 kgf*cm, 75 in.*lbf }

      Note

      Do not twist the rear speed sensor when installing it.

8. INSTALL REAR DISC

   Click here

9. CONNECT REAR DISC BRAKE CALIPER ASSEMBLY LH

   
   

   1. Connect the rear disc brake caliper assembly with the 2 bolts.

      Torque:

      88 N*m  { 897 kgf*cm, 65 ft.*lbf }

10. STAKE REAR AXLE SHAFT NUT LH (for 4WD/AWD)

    

    
    

    1. Using a chisel and hammer, stake the rear axle shaft nut.

11. INSPECT AND ADJUST PARKING BRAKE

    Click here

12. INSTALL REAR WHEEL

    Torque:

    103 N*m  { 1050 kgf*cm, 76 ft.*lbf }

13. INSPECT AND ADJUST REAR WHEEL ALIGNMENT

    Click here

14. CHECK FOR SPEED SENSOR SIGNAL

    Click here