FRONT AXLE HUB BOLT REPLACEMENT

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. REMOVE FRONT WHEEL

  2. DISCONNECT FRONT FLEXIBLE HOSE


    1. A01V859

      Remove the bolt and disconnect the flexible hose.

  3. DISCONNECT FRONT DISC BRAKE CALIPER ASSEMBLY LH


    1. A01V80M

      Remove the 2 bolts and disconnect the front disc brake caliper assembly from the steering knuckle.

      Note

      Use wire or an equivalent tool to keep the brake caliper from hanging down by the flexible hose.

  4. REMOVE FRONT DISC


  5. REMOVE FRONT AXLE HUB BOLT LH

    A01VADZC01
    *1 Nut
    *a Hold
    *b Turn

    1. Temporarily install 2 nuts and 2 washers to the front axle hub bolt as shown in the illustration.

    2. Using SST and a brass bar or an equivalent tool to hold the front axle, remove the front axle hub bolt.

      SST
      09611-12010

  6. INSTALL FRONT AXLE HUB BOLT LH


    1. A01VARIC01
      *1 Washer
      *2 Nut
      *a Hold
      *b Turn

      Install a washer and nut to a new front axle hub bolt as shown in the illustration.

    2. Using a brass bar or an equivalent tool to hold the front axle, install the hub bolt by tightening the nut.

    3. Remove the nut and plate washer.

  7. INSTALL FRONT DISC


  8. CONNECT FRONT DISC BRAKE CALIPER ASSEMBLY LH


    1. Connect the front disc brake caliper assembly to the steering knuckle with the 2 bolts.

      Torque:
      106.8 N*m  { 1089 kgf*cm, 79 ft.*lbf }

  9. CONNECT FRONT FLEXIBLE HOSE


    1. Connect the front flexible hose to the steering knuckle with the bolt.

      Torque:
      29 N*m  { 296 kgf*cm, 21 ft.*lbf }

  10. INSTALL FRONT WHEEL

    Torque:
    103 N*m  { 1050 kgf*cm, 76 ft.*lbf }