REAR DRIVE SHAFT ASSEMBLY REMOVAL

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. REMOVE REAR WHEEL

  2. REMOVE REAR AXLE SHAFT NUT LH

    Click here

  3. DISCONNECT REAR SPEED SENSOR LH

    Click here

  4. DISCONNECT DIFFERENTIAL CARRIER ASSEMBLY

    Click here

  5. REMOVE REAR DRIVE SHAFT ASSEMBLY LH


    1. A01V72IC01
      *a Rib

      With ribs:

      Set the tip of the tire lever to the position on the rear drive shaft inboard joint assembly LH shown in the illustration. Then, using the ribbed part of the rear differential carrier assembly as a fulcrum, disconnect the rear drive shaft assembly LH.

      Note

      Do not scratch the rear drive shaft dust cover.

    2. A01V6XJ

      Without ribs:

      Set the tip of a wheel nut wrench to the position on the rear drive shaft inboard joint assembly LH shown in the illustration. Then, using a brass bar as a fulcrum, disconnect the rear drive shaft assembly LH.

      Note

      Do not scratch the rear drive shaft dust cover.

    3. A01V7PIC01
      *a Matchmark

      Put matchmarks on the rear drive shaft assembly LH and rear axle hub assembly.

      Note

      Do not use a punch to make the matchmarks.

    4. Using a plastic-faced hammer, remove the rear drive shaft assembly LH from the rear axle hub assembly.

      Note


      • Be careful not to damage the boot, dust cover and speed sensor rotor.

      • Do not excessively push out the rear drive shaft assembly LH from the rear axle hub assembly.

  6. REMOVE REAR DRIVE SHAFT INBOARD JOINT SHAFT SNAP RING LH

    A01VAC4

    1. Using a screwdriver, remove the rear drive shaft inboard joint shaft snap ring LH.