REAR DRIVE SHAFT ASSEMBLY INSPECTION

CAUTION / NOTICE / HINT

Note


  • When using a vise, place aluminum plates between the part and vise.

  • When using a vise, do not overtighten it.

PROCEDURE


  1. INSPECT REAR DRIVE SHAFT ASSEMBLY


    1. A00YWRA

      Check that there is no excessive play in the radial direction of the outboard joint.

    2. Check that the inboard joint slides smoothly in the thrust direction.

    3. Check that there is no severe play in the radial direction of the inboard joint.

    4. Check the 2 joint boots for damage.

    5. A00YV8YN04

      Check that the 2 joint boots are not stretched or contracted when the rear drive shaft assembly is at the standard length.

      Length (A)
      733.2 mm (2.40 ft.)

      Note

      Keep the drive shaft assembly level during inspection.

      If the boots are stretched or contracted, correct them.