FRONT DRIVE SHAFT ASSEMBLY(for 4WD/AWD) INSPECTION

CAUTION / NOTICE / HINT

Note


  • When using a vise, place aluminum plates between the part and vise.

  • When using a vise, do not overtighten it.

PROCEDURE


  1. INSPECT FRONT DRIVE SHAFT ASSEMBLY


    1. A01QTJQ

      Check that there is no excessive play in the radial direction of the outboard joint.

    2. Check that the inboard joint slides smoothly in the thrust direction.

    3. Check that there is no severe play in the radial direction of the inboard joint.

    4. Check the 2 joint boots for damage.

    5. A01QPCVC01
      *A for LH Side
      *B for RH Side

      Check that the 2 joint boots are not stretched or contracted when the front drive shaft is at the standard length.

      Length (A)
      Item Length
      for 2AD-FTV, 2AD-FHV (Automatic Transaxle) LH Side 565.6 mm (1.86 ft.)
      RH Side 928.4 mm (3.05 ft.)
      for 2AD-FTV, 2AD-FHV (Manual Transaxle) LH Side 553.6 mm (1.82 ft.)
      RH Side 933.9 mm (3.06 ft.)
      for 2AR-FE (Automatic Transaxle) LH Side 577.6 mm (1.89 ft.)
      RH Side 922.4 mm (3.03 ft.)
      for 2AR-FE (Manual Transaxle) LH Side 583.6 mm (1.91 ft.)
      RH Side 909.4 mm (2.98 ft.)
      for 3ZR-FE, 3ZR-FAE (Manual Transaxle) LH Side 594.6 mm (1.95 ft.)
      RH Side 896.4 mm (2.94 ft.)
      for 3ZR-FE (CVT) LH Side 591.2 mm (1.94 ft.)
      RH Side

      881.9 mm (2.89 ft.)*1

      893.0 mm (2.93 ft.)*2
      for 3ZR-FAE (CVT) LH Side 591.2 mm (1.94 ft.)
      RH Side 893.0 mm (2.93 ft.)

      *1: for K111

      *2: for K114

      Note

      Keep the drive shaft assembly level during inspection.

      If the boots are stretched or contracted, correct them.