DYNAMIC TORQUE CONTROL 4WD/AWD SYSTEM DIAGNOSIS SYSTEM

DESCRIPTION

Dynamic torque control 4WD/AWD system data can be read through the Data Link Connector 3 (DLC3) of the vehicle. When the system seems to be malfunctioning, use the GTS to check for malfunctions and perform repairs. Therefore when there seems to be a problem with the dynamic torque control 4WD/AWD system, use the GTS or SST to check and troubleshoot it.

CHECK DATA LINK CONNECTOR 3 (DLC3)

1. Check the DLC3.

   Click here

FUNCTION OF 4WD/AWD WARNING LIGHT

1. for Segment Display Type:

   The 4WD/AWD warning light in the combination meter warns the driver of abnormal or poor condition of the dynamic torque control 4WD/AWD system.

   for TFT Display Type:

   The 4WD/AWD warning message displayed on the multi-information display warns the driver of abnormal or poor condition of the dynamic torque control 4WD/AWD system.

2. for Segment Display Type:

   If the 4WD ECU assembly detects a malfunction, the 4WD/AWD warning light comes on in accordance with the trouble area to warn the driver.

   for TFT Display Type:

   If the 4WD ECU assembly detects a malfunction, the check master warning light comes on and the multi-information display displays warning messages in accordance with the trouble area to warn the driver.

   Tech Tips

   Check that the master warning light comes on for approximately 4 seconds.

CHECK WARNING LIGHT AND INDICATOR LIGHT

1. Check warning and indicator lights.

   
   

   1. When the ignition switch is turned to ON, check that the 4WD/AWD warning*1, sport mode indicator*2 and 4WD/AWD lock mode indicator lights come on and go off within approximately 4 seconds.

      
      

      • *1: for Segment Display Type

      • *2: for Manual Transaxle

      Tech Tips

      If the warning and indicator lights do not illuminate, check for combination meter assembly and CAN communication system DTCs, since the 4WD ECU assembly and combination meter assembly are connected by the CAN communication line.

      If the warning light remains on, perform relevant troubleshooting procedures. The relevant troubleshooting procedures are in the sections listed in the table below.

2. Check 4WD/AWD warning (for TFT Display Type).

   
   
   1. 

      *a	Front view of DLC3

      Using SST, connect terminals 13 (TC) and 4 (CG) of the DLC3 (to enter diagnostic mode).

      SST

      09843-18040

   2. Turn the ignition switch to ON.

   3. "DIAG 4WD" or "DIAG AWD" is displayed on the multi-information display, and the 4WD ECU assembly checks the system for malfunctions.

      
      

      • If the dynamic torque control AWD system is normal, "DIAG 4WD FF" or "DIAG AWD FF"is displayed on the multi-information display.

      • If the dynamic torque control AWD system is not normal, "DIAG 4WD XX (DTC)" or "DIAG AWD XX (DTC)" is displayed on the multi-information display.

      • Although the test mode is not set for the dynamic torque control 4WD/AWD system, the message is displayed on the multi-information display when the test mode is activated for checking the VSC, etc.

      Tech Tips

      
      

      • Test mode DTCs will not be stored because the test mode is not set.

      • If the systems above are not displayed on the multi-information display, there may be a malfunction in "TC and CG Terminal Circuit".

        Click here

      • If the 4WD/AWD warning check result is not normal, proceed to troubleshooting for the 4WD/AWD warning light circuit.

• *: for Manual Transaxle