FRONT DIFFERENTIAL OIL SEAL(for LH Side) REPLACEMENT

PROCEDURE


  1. REMOVE NO. 1 ENGINE UNDER COVER

    Click here

  2. REMOVE REAR ENGINE UNDER COVER LH

    Click here

  3. DRAIN CONTINUOUSLY VARIABLE TRANSAXLE FLUID


    1. A01V7G9

      Remove the refill plug and gasket from the continuously variable transaxle assembly.

    2. A01VA56

      Using a 10 mm hexagon socket wrench, remove the drain plug and gasket from the transaxle oil (CVT) pan sub-assembly, and drain the fluid.

    3. Install a new gasket and the drain plug to the transaxle oil (CVT) pan sub-assembly.

      Torque:
      49 N*m  { 500 kgf*cm, 36 ft.*lbf }

    4. Temporarily install the gasket and refill plug to the continuously variable transaxle assembly.

      Tech Tips

      Reuse the old gasket. The refill plug will be removed again to adjust the fluid level.

  4. REMOVE FRONT DRIVE SHAFT ASSEMBLY LH

    Click here

  5. REMOVE FRONT DRIVE SHAFT OIL SEAL LH

    A01V7X4N01

    1. Using SST, remove the front drive shaft oil seal LH from the continuously variable transaxle assembly.

      SST
      09308-00010

      Note

      Do not damage the continuously variable transaxle assembly.

  6. INSTALL FRONT DRIVE SHAFT OIL SEAL LH


    1. Apply MP grease to the lip of a new front drive shaft oil seal LH.

    2. A01VA39C03
      *a -0.5 to 0.5 mm (-0.0197 to 0.0196 in.)

      Using SST and a hammer, install the front drive shaft oil seal LH to the continuously variable transaxle assembly.

      SST
      09316-10010
      09950-70010   ( 09951-07150 )
      Standard depth
      -0.5 to 0.5 mm (-0.0197 to 0.0196 in.)

      Note


      • Be sure to install the front drive shaft oil seal LH in the correct direction.

      • Make sure to install the front drive shaft oil seal LH as specified, otherwise malfunctions such as a fluid leak will occur.

      • Do not damage the lip of the front drive shaft oil seal LH.

  7. INSTALL FRONT DRIVE SHAFT ASSEMBLY LH

    Click here

  8. ADD CONTINUOUSLY VARIABLE TRANSAXLE FLUID

    Click here

  9. INSPECT FOR FLUID LEAK

  10. INSTALL REAR ENGINE UNDER COVER LH

    Click here

  11. INSTALL NO. 1 ENGINE UNDER COVER

    Click here