SHIFT PADDLE SWITCH INSPECTION

PROCEDURE

1. INSPECT TRANSMISSION SHIFT SWITCH ASSEMBLY

   

   *a	LH
   *b	RH
   *c	Component without wire harness connected (Transmission Shift Switch Assembly)

   
   

   1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      for LH Tester Connection Shift Position Specified Condition SFTD - ECC "-" shift paddle operated and held (down-shift) Below 2.5 Ω SFTD - ECC1 "-" shift paddle operated and held (down-shift) Below 2.5 Ω SFTD - ECC "-" shift paddle not operated (down-shift) 1 MΩ or higher SFTD - ECC1 "-" shift paddle not operated (down-shift) 1 MΩ or higher
      for RH Tester Connection Shift Position Specified Condition SFTU - ECC "+" shift paddle operated and held (up-shift) Below 2.5 Ω SFTU - ECC "+" shift paddle not operated (up-shift) 1 MΩ or higher

      If the result is not as specified, replace the transmission shift switch assembly.

2. INSPECT NO. 1 SWITCH WIRE

   
   

   1. Connect the No. 1 switch wire connector to the transmission shift switch assembly.

   2. Disconnect the steering pad switch connector from the No. 1 switch wire.

   3. 

      *a	Component without wire harness connected (No. 1 Switch Wire)

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Switch Condition Specified Condition SFTD - ECC "-" shift paddle operated and held (down-shift) Below 2.5 Ω SFTU - ECC "+" shift paddle operated and held (up-shift) Below 2.5 Ω SFTD - ECC "-" shift paddle not operated (down-shift) 1 MΩ or higher SFTU - ECC "+" shift paddle not operated (up-shift) 1 MΩ or higher