TRANSMISSION CONTROL CABLE REMOVAL

PROCEDURE


  1. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.

    Click here

  2. REMOVE NO. 2 CYLINDER HEAD COVER

  3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable some systems need to be initialized after the cable is reconnected.

    Click here

  4. REMOVE BATTERY CLAMP SUB-ASSEMBLY

    Click here

  5. REMOVE BATTERY

  6. REMOVE BATTERY TRAY

  7. REMOVE FRONT BATTERY BRACKET

    Click here

  8. REMOVE BATTERY BRACKET REINFORCEMENT

    Click here

  9. REMOVE AIR CLEANER CAP AND HOSE

    Click here

  10. REMOVE AIR CLEANER CASE

    Click here

  11. REMOVE FRONT FLOOR COVER

    Click here

  12. REMOVE REAR CONSOLE BOX SUB-ASSEMBLY

    Click here

  13. REMOVE TRANSMISSION CONTROL CABLE ASSEMBLY


    1. Move the shift lever to N.

    2. A01G9YL

      Disconnect the end of the transmission control cable assembly from the shift lever.

    3. A01GBRCC02
      *1 Stopper
      *2 Nut

      Pull out the stopper of the transmission control cable assembly.

    4. Rotate the nut of the transmission control cable assembly counterclockwise approximately 180° and, while holding the nut in that position, disconnect the transmission control cable assembly from the shift lever retainer.

      Note

      Do not over-rotate the nut as it will come off the internal spring and the transmission control cable assembly will not be reusable.

    5. A01GC1Z

      Remove the nut and disconnect the control cable assembly from the control shaft lever.

    6. Remove the clip and disconnect the transmission control cable assembly from the control cable bracket.

    7. A01GC5S

      Disconnect the transmission control cable assembly from the control cable support.

    8. A01GCPT

      Remove the bolt and disconnect the clamp of the transmission control cable assembly.

    9. A01GC66

      Remove the 2 bolts and disconnect the transmission control cable assembly.

    10. Pull out the transmission control cable assembly to remove it.