TRANSMISSION CONTROL CABLE

INSTALL TRANSMISSION CONTROL CABLE ASSEMBLY

Note

Before installing the transmission control cable assembly, check that the park/neutral position switch assembly and shift lever are in neutral.

Put the transmission control cable assembly into the cabin and connect the transmission control cable assembly with the 2 bolts.

Torque:

5.0 N*m { 51 kgf*cm, 44 in.*lbf }
Connect the clamp of the transmission control cable assembly with the bolt.

Torque:

5.0 N*m { 51 kgf*cm, 44 in.*lbf }
Connect the transmission control cable assembly to the control cable support.
Connect the transmission control cable assembly to the bracket with a new clip.
Connect the transmission control cable assembly to the control shaft lever with the nut.

Torque:

12 N*m { 122 kgf*cm, 9 ft.*lbf }

Turn the nut of the transmission control cable 180° counterclockwise. While holding the nut in place, push in the stopper to lock the nut.

Note

Do not over-rotate the nut as it will come off the internal spring and the transmission control cable will not be reusable.

*1	Stopper	*2	Nut
*a	Push in	-	-

Tech Tips

If the stopper cannot be pushed in, slightly turn the nut clockwise and then push in the stopper again.

Install the outer part of the transmission control cable assembly to the shift lever retainer. Check that the stopper returns to the pulled out position.

*1	Stopper	*2	Nut
*3	Shift Lever Retainer	-	-

*1 Slider

*2 Lock Piece

Slide the slider in the direction shown in the illustration and pull out the lock piece.
Connect the end of the transmission control cable assembly to the shift lever.
Note
- Make sure that the lock piece is pulled up.
- Push on the end of the transmission control cable assembly all the way to the base of the pin.
*1 Cable Rod

Gently pull the cable rod toward the rear of the vehicle by hand to pull the cable taut.
Push the lock piece into the adjuster case and lock it.

Note

Make sure that the lock piece is completely locked by the slider.