TRANSMISSION CONTROL CABLE ADJUSTMENT

PROCEDURE


  1. INSPECT SHIFT LEVER POSITION


    1. When moving the shift lever from P to R with the ignition switch ON and the brake pedal depressed, make sure that the shift lever moves smoothly and correctly into position.

    2. Start the engine and make sure that the vehicle moves forward after moving the shift lever from N to D and moves in reverse after moving the shift lever to R.

      If the operation cannot be performed as specified, inspect the park/neutral position switch assembly and check the shift lever assembly installation condition.

  2. ADJUST SHIFT LEVER POSITION


    1. Remove the rear console box sub-assembly.

      Click here

    2. Apply the parking brake and move the shift lever to N.

    3. A01QOF2C12
      *1 Slider
      *2 Lock Piece

      Slide the slider in the direction shown in the illustration and pull out the lock piece.

    4. A01QSJQC03
      *1 Cable Rod

      Gently pull the cable rod toward the rear of the vehicle by hand to pull the cable taut.

    5. Press the lock piece into the adjuster case and lock it.

      Note

      Make sure that the lock piece is completely locked by the slider.

    6. Inspect the operation of the shift lever.

      Click here

    7. Install the rear console box sub-assembly.

      Click here