SHIFT LEVER INSTALLATION

PROCEDURE


  1. INSTALL SHIFT LEVER ASSEMBLY


    1. A01QU51N02

      Install the shift lever assembly with the 4 bolts. Tighten the bolts in the order shown in the illustration.

      Torque:
      12 N*m  { 122 kgf*cm, 9 ft.*lbf }

    2. Connect the 2 connectors and attach the 4 harness clamps to the shift lever assembly.

  2. CONNECT TRANSMISSION CONTROL CABLE ASSEMBLY


    1. Turn the nut of the transmission control cable 180° counterclockwise. While holding the nut in place, push in the stopper to lock the nut.

      A01QSFDC02
      *1 Stopper *2 Nut
      *a Push in - -

      Note

      Do not over-rotate the nut as it will come off the internal spring and the transmission control cable assembly will not be reusable.

      Tech Tips

      If the stopper cannot be pushed in, slightly turn the nut clockwise and then push in the stopper again.

    2. Connect the outer part of the transmission control cable assembly to the shift lever assembly. Check that the stopper returns to the pulled-out position.

      A01QRLGC02
      *1 Stopper *2 Nut
      *3 Shift Lever Assembly - -
    3. A01QOF2C11
      *1 Slider
      *2 Lock Piece

      Slide the slider in the direction shown in the illustration and pull out the lock piece.

    4. A01QTMC

      Connect the end of the transmission control cable assembly to the shift lever.

      Note


      • Make sure that the lock piece is pulled up.


      • Push on the end of the transmission control cable assembly all the way to the base of the pin.

    5. Gently pull the cable rod toward the rear of the vehicle by hand to pull the cable taut.

    6. A01QUJ7C01
      *1 Cable Rod
      *a Push in

      Push the lock piece into the adjuster case and lock it.

      Note

      Make sure that the lock piece is completely locked by the slider.

  3. ADJUST SHIFT LEVER POSITION

    Click here

  4. INSTALL REAR CONSOLE BOX SUB-ASSEMBLY

    Click here