DIFFERENTIAL CASE DISASSEMBLY

PROCEDURE


  1. REMOVE FRONT DIFFERENTIAL CASE OIL SEAL


    1. Mount the front differential ring gear in a vise between aluminum plates.

      Note


      • Be careful not to damage the front differential ring gear.


      • Do not overtighten the vise.

    2. A01GCKUN01

      Using SST, remove the front differential case oil seal from the front differential case.

      SST
      09308-00010

  2. REMOVE FRONT DIFFERENTIAL RING GEAR


    1. Mount the front differential ring gear in a vise between aluminum plates.

      Note


      • Be careful not to damage the front differential ring gear.


      • Do not overtighten the vise.

    2. A01GCURC01
      *a Matchmark

      Put matchmarks on the front differential ring gear and front differential case.

    3. A01GBDP

      Remove the 12 bolts.

    4. Using a plastic-faced hammer, remove the front differential case from the front differential ring gear.

    5. Remove the front differential ring gear.

  3. INSPECT FRONT DIFFERENTIAL CASE

    Click here

  4. INSPECT FRONT DIFFERENTIAL SIDE GEAR THRUST AMOUNT

    Click here

  5. REMOVE FRONT DIFFERENTIAL PINION SHAFT STRAIGHT PIN


    1. A01GAOB

      Using a 5 mm pin punch and hammer, remove the front differential pinion shaft straight pin from the front differential case.

  6. REMOVE FRONT NO. 1 DIFFERENTIAL PINION SHAFT


    1. A01GC8J

      Remove the front No. 1 differential pinion shaft from the front differential case.

  7. INSPECT FRONT DIFFERENTIAL PINION BACKLASH

    Click here

  8. REMOVE FRONT DIFFERENTIAL SIDE GEAR


    1. Set SST as shown in the illustration and tighten it.

      SST
      09528-52010   ( 09953-05010, 09528-05010 )
      A01GA50C01
      *a Turn *b Hold

      Note

      Do not overtighten SST, as doing so will damage the front differential side gear, center differential side gear conical spring washer, front No. 1 differential side gear thrust washer and front differential case.

      Tech Tips


      • Tighten SST until there is a clearance between the front differential pinions and front differential side gears.

      • When removing the front differential pinions, do not overtighten SST, as it is necessary to rotate the front differential side gears.

    2. A01GDDAC01
      *a Turn

      Install SST as shown in the illustration, rotate the front differential side gear, and then remove the 2 front differential pinions and 2 front differential pinion thrust washers from the front differential case.

      SST
      09528-52010   ( 09528-05030 )

      Note

      Do not drop the front differential pinion or front differential pinion thrust washer.

    3. A01GBMLC01
      *1 Front Differential Side Gear
      *2 Center Differential Side Gear Conical Spring Washer
      *3 Front No. 1 Differential Side Gear Thrust Washer

      Remove SST from the front differential case, and then remove the 2 front differential side gears, 2 front No. 1 differential side gear thrust washers and 2 center differential side gear conical spring washers from the front differential case.

      Note

      Do not drop the front differential side gear, front No. 1 differential side gear thrust washer and center differential side gear conical spring washer.