TRANSMISSION CONTROL CABLE INSTALLATION

PROCEDURE


  1. INSTALL TRANSAXLE CONTROL CABLE ASSEMBLY


    1. Install the transaxle control cable assembly with the 2 bolts.

      Torque:
      5.0 N*m  { 51 kgf*cm, 44 in.*lbf }

    2. Connect the transaxle control cable assembly to the control cable bracket, and install 2 new clips.

    3. Connect the transaxle control cable assembly to the manual transaxle assembly, and install the 2 clips.

  2. CONNECT ENGINE WIRE


    1. Connect the engine wire with bolt and clamp.

      Torque:
      7.7 N*m  { 79 kgf*cm, 68 in.*lbf }

  3. INSTALL AIR CLEANER BRACKET

    Click here

  4. INSTALL NO. 2 ENGINE UNDER COVER

    Click here

  5. INSTALL FRONT FLOOR COVER

    Click here

  6. CONNECT TRANSAXLE CONTROL CABLE ASSEMBLY


    1. Turn the lock nut of the transaxle control cable assembly 180° clockwise. While holding the lock nut in place, push in the stopper to lock the lock nut.

      A01GCMMC01
      *1 Cable Lock *2 Lock Nut
      *a Push in - -

      Note

      Do not over-rotate the nut as it will come off the internal spring and the transaxle control cable assembly will not be reusable.

      Tech Tips

      If the stopper cannot be pushed in, slightly turn the nut counterclockwise and then push in the cable lock again.

    2. Connect the outer part of the transaxle control cable assembly to the floor shift shift lever assembly. Check that the stopper returns to the pulled-out position.

      A01GB1NC01
      *1 Cable Lock *2 Lock Nut
      *3 Floor Shift Shift Lever Assembly - -
    3. A01GBO5C01
      *1 Slider
      *2 Lock Piece

      Slide the slider in the direction shown in the illustration and pull out the lock piece.

    4. A01GAL9C01
      *1 Select Control Cable
      *2 Shift Control Cable

      Connect the shift control cable to the floor shift shift lever assembly.

    5. Gently pull the cable rod toward the rear of the vehicle by hand to pull the cable taut.

    6. A01GABF

      Push the lock piece into the adjuster case and lock it.

      Note

      Make sure that the lock piece is completely locked by the slider.

    7. A01G9XQ

      Install a new clip to the select control cable.

      Tech Tips

      Install a new clip.

  7. INSTALL REAR CONSOLE BOX SUB-ASSEMBLY

    Click here