CLUTCH PEDAL(for RHD) INSTALLATION

PROCEDURE


  1. INSTALL CLUTCH PEDAL PAD


    1. Install the clutch pedal pad to the clutch pedal sub-assembly.

  2. INSTALL NO. 1 CLUTCH PEDAL CUSHION

    A01V9RV

    1. Install the No. 1 clutch pedal cushion to the clutch pedal sub-assembly.

  3. INSTALL CLUTCH PEDAL SHAFT COLLAR

    A01V7YSC01
    A01V9RL MP grease

    1. Apply MP grease to both sides of the clutch pedal shaft collar and 2 new bushes.

    2. Install the clutch pedal shaft collar.

    3. Install the 2 bushes.

  4. INSTALL CLUTCH PEDAL SPRING HOLDER

    A01V73YC01
    A01V9RL MP grease

    1. Apply MP grease to the contact surface of the clutch pedal spring holder.

    2. Install the clutch pedal spring holder.

  5. INSTALL CLUTCH PEDAL SUB-ASSEMBLY

    A01V8QB

    1. Install the clutch pedal to the clutch pedal support with the bolt and nut.

      Torque:
      37 N*m  { 377 kgf*cm, 27 ft.*lbf }

      Tech Tips

      Install the bolt from the left side of the vehicle.

  6. INSTALL PEDAL WITH HOOK SPRING

    A01VAWSC01
    A01V9RL MP grease

    1. Apply MP grease to the contact surface of the clutch pedal sub-assembly.

    2. Install the pedal with hook spring.

  7. INSTALL CLUTCH SWITCH ASSEMBLY

    Click here

  8. INSTALL CLUTCH START SWITCH ASSEMBLY

    Click here

  9. INSTALL CLUTCH PEDAL SUPPORT SUB-ASSEMBLY


    1. Apply MP grease to the contact surface of the clutch master cylinder push rod clevis and the clutch pedal support sub-assembly.

    2. A01VAURC01
      A01V9RL MP grease

      Install the clutch master cylinder push rod clevis to the cutout of the clutch pedal sub-assembly from the left side of the vehicle and push it downward.

    3. Install the clutch pedal support sub-assembly with the 2 bolts and 2 nuts.

      Torque:
      for bolt
      24 N*m  { 245 kgf*cm, 18 ft.*lbf }
      for nut
      13 N*m  { 133 kgf*cm, 10 ft.*lbf }

      Note

      Check that the push rod cannot be turned 30° or more in order to confirm that the clevis is securely engaged in the pedal.

    4. Connect the 2 connectors and 2 clamps.

  10. INSTALL NO. 2 AIR DUCT SUB-ASSEMBLY

    Click here

  11. INSTALL LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY (w/ Driver Side Knee Airbag)

    Click here

  12. INSPECT AND ADJUST CLUTCH PEDAL SUB-ASSEMBLY

    Click here