CLUTCH UNIT(for 2AR-FE) INSPECTION

PROCEDURE


  1. INSPECT CLUTCH DISC ASSEMBLY

    A00YT1T

    1. Using a vernier caliper, measure the rivet head depth.

      Minimum rivet depth
      0.3 mm (0.0118 in.)

      If the depth is less than the minimum, replace the clutch disc assembly.

    2. Install the clutch disc assembly onto the manual transaxle assembly.

      Tech Tips

      Insert the clutch disc assembly in the correct direction.

    3. A00YRC4

      Using a dial gauge, measure the clutch disc assembly runout.

      Maximum runout
      0.8 mm (0.0314 in.)

      If the runout is more than the maximum, replace the clutch disc assembly.

  2. INSPECT CLUTCH COVER ASSEMBLY

    A00YVKME01

    1. Using a vernier caliper, measure the depth and width of the diaphragm spring wear.

      Maximum depth A
      0.5 mm (0.0196 in.)
      Maximum width B
      6.0 mm (0.236 in.)

      If the depth or width is more than the maximum, replace the clutch cover assembly.

  3. INSPECT FLYWHEEL SUB-ASSEMBLY

    A00YSXG

    1. Using a dial gauge, check the flywheel sub-assembly runout.

      Maximum runout
      0.1 mm (0.00393 in.)

      If the runout is more than the maximum, replace the flywheel sub-assembly.