OIL PUMP REASSEMBLY

PROCEDURE


  1. INSTALL FRONT OIL PUMP OIL SEAL


    1. A00YSWQN01

      Coat the lip of a new front oil pump oil seal with a small amount of MP grease.

    2. Using SST and a hammer, install the front oil pump oil seal to the front oil pump body sub-assembly.

      SST
      09350-32014   ( 09351-32140 )

      Note

      The seal end should be level with the outer edge of the front oil pump body sub-assembly.

  2. INSTALL FRONT OIL PUMP BODY O-RING


    1. A00YXIR

      Coat a new front oil pump body O-ring with ATF and install it to the front oil pump body sub-assembly.

      Note

      Ensure that the O-ring is not twisted.

  3. INSTALL FRONT OIL PUMP DRIVEN GEAR


    1. A00YT2V

      Coat the front oil pump driven gear with ATF and install it to the front oil pump body sub-assembly with the marked side up.

  4. INSTALL FRONT OIL PUMP DRIVE GEAR


    1. A00YQSK

      Coat the front oil pump drive gear with ATF, and install it to the front oil pump body sub-assembly with the marked side up.

  5. INSTALL STATOR SHAFT ASSEMBLY


    1. A00YTL0N02

      Align each knock pin of the stator shaft assembly with the holes in the front oil pump body sub-assembly and install the stator shaft assembly to the front oil pump body sub-assembly with the 16 bolts.

      Bolt Length
      Bolt Length
      A 14 mm (0.551 in.)
      B 26 mm (1.02 in.)

    2. Using a T30 "TORX" socket wrench, tighten the 16 bolts.

      Torque:
      9.3 N*m  { 95 kgf*cm, 82 in.*lbf }

  6. INSPECT OIL PUMP ASSEMBLY

    Click here