PARK / NEUTRAL POSITION SWITCH REMOVAL

PROCEDURE


  1. REMOVE AIR CLEANER CAP SUB-ASSEMBLY

    Click here

  2. REMOVE AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY

  3. REMOVE AIR CLEANER CASE SUB-ASSEMBLY

    Click here

  4. REMOVE PARK/NEUTRAL POSITION SWITCH ASSEMBLY


    1. A00YX2Y

      Remove the nut and transmission control cable assembly from the transmission control shaft lever.

    2. Disconnect the connector from the park/neutral position switch assembly.

    3. A00YRZ0

      Remove the nut, washer and transmission control shaft lever from the manual valve lever shaft sub-assembly.

    4. A00YR73

      Remove the 2 bolts and park/neutral position switch assembly from the automatic transaxle assembly.

      Note

      Before removing the park/neutral position switch assembly, remove any dirt or rust on the installation portion of the manual valve lever shaft sub-assembly. Be sure to remove the switch straight along the shaft while being careful not to deform the plate spring that supports the shaft. If the plate spring is deformed, the park/neutral switch cannot be reinstalled correctly.