LANE DEPARTURE ALERT BUZZER REMOVAL

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.

PROCEDURE


  1. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.

    Click here

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    Note

    When disconnecting the cable some systems need to be initialized after the cable is reconnected.

    Click here

  3. REMOVE CENTER NO. 1 INSTRUMENT CLUSTER FINISH PANEL

    Click here

  4. REMOVE TELLTALE LIGHT ASSEMBLY

    Click here

  5. REMOVE NO. 3 INSTRUMENT PANEL REGISTER ASSEMBLY

    Click here

  6. REMOVE NO. 4 INSTRUMENT PANEL REGISTER ASSEMBLY

    Click here

  7. REMOVE STEREO OPENING COVER (w/o Audio)

    Click here

  8. REMOVE RADIO RECEIVER ASSEMBLY WITH BRACKET (w/ Radio Receiver)

    Click here

  9. REMOVE NAVIGATION RECEIVER ASSEMBLY WITH BRACKET (w/ Navigation System)

    Click here

  10. REMOVE SKID CONTROL BUZZER ASSEMBLY (LANE DEPARTURE ALERT BUZZER)

    A00YTQ0

    1. Detach the clamp.

    2. Disconnect the connector and remove the skid control buzzer (lane departure alert buzzer).