CRUISE CONTROL MAIN SWITCH INSPECTION

PROCEDURE


  1. INSPECT CRUISE CONTROL MAIN SWITCH


    1. Measure the resistance according to the value(s) in the table below.

      A00YRJPC01
      *1 Cruise Control Switch (ON-OFF button) - -
      *a

      Component without harness connected

      (Cruise Control Main Switch)

      		 *b ON-OFF
      *c +/RES *d -/SET
      *e CANCEL - -
      Standard Resistance
      Tester Connection Condition Specified Condition
      1 - 3 Cruise control switch (ON-OFF button) released 1 MΩ or higher
      Cruise control switch (ON-OFF button) pushed Below 2.5 Ω
      +/RES 235 to 245 Ω
      -/SET 617 to 643 Ω
      CANCEL 1509 to 1571 Ω

      If the result is not as specified, replace the cruise control main switch.