FORWARD RECOGNITION CAMERA SYSTEM TERMINALS OF ECU


  1. CHECK FORWARD RECOGNITION CAMERA

    B0029PXC08

    1. Disconnect the Q17 forward recognition camera connector.

      Note


      • DTCs may be output when connectors are disconnected during inspection. Therefore, be sure to clear the DTCs using the GTS once the inspection has been completed.

      • Do not apply excessive force to the Q17 forward recognition camera connector.

    2. Measure the voltage and resistance according to the value(s) in the table below.

      Terminal No. (Symbol) Wiring Color Terminal Description Condition Specified Condition
      Q17-7 (IGB) - Body ground GR - Body ground Power source Ignition switch ON 11 to 14 V
      Ignition switch off Below 1 V
      Q17-10 (GND) - Body ground W-B - Body ground Ground Always Below 1 Ω

      Tech Tips

      If the result is not as specified, there may be a malfunction on the wire harness side.

    3. Reconnect the Q17 forward recognition camera connector.

    4. w/ Camera Heater:

      Measure the voltage according to the value(s) in the table below.

      Terminal No. (Symbol) Wiring Color Terminal Description Condition Specified Condition
      Q17-1 (HTR) - Body ground R - Body ground Forward recognition with heater hood sub-assembly operation signal Ignition switch ON, and the forward recognition with heater hood sub-assembly operating Below 1 V
      Ignition switch ON, and the forward recognition with heater hood sub-assembly not operating 11 to 14 V

    5. Check for pulses according to the value(s) in the table below.

      Terminal No. (Symbol) Wiring Color Terminal Description Condition Specified Condition
      Q17-5 (CA1P) - Q17-10 (GND) G - W-B CAN communication signal Ignition switch ON

      Pulse generation

      (See waveform 1)
      Q17-11 (CA1N) - Q17-10 (GND) LG - W-B CAN communication signal Ignition switch ON

      Pulse generation

      (See waveform 2)
      Q17-6 (CANH) - Q17-10 (GND) L - W-B CAN communication signal Ignition switch ON

      Pulse generation

      (See waveform 1)
      Q17-12 (CANL) - Q17-10 (GND) W - W-B CAN communication signal Ignition switch ON

      Pulse generation

      (See waveform 2)
    6. B002AFIE03
      *a 1 V/DIV.
      *b 10 μsec./DIV.

      WAVEFORM 1


      1. CAN communication signal

        Item Content
        Terminal Name

        Between Q17-5 (CA1P) and Q17-10 (GND)

        Between Q17-6 (CANH) and Q17-10 (GND)
        Tester Range 1 V/DIV., 10 μsec./DIV.
        Condition Ignition switch ON

        Tech Tips

        The waveform varies depending on the CAN communication signal.

    7. B0029ETE07
      *a 1 V/DIV.
      *b 10 μsec./DIV.

      WAVEFORM 2


      1. CAN communication signal

        Item Content
        Terminal Name

        Between Q17-11 (CA1N) and Q17-10 (GND)

        Between Q17-12 (CANL) and Q17-10 (GND)
        Tester Range 1 V/DIV., 10 μsec./DIV.
        Condition Ignition switch ON

        Tech Tips

        The waveform varies depending on the CAN communication signal.