DATA LIST
Tech Tips
Using the GTS to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.
Note
In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
for 2WW:
Enter the following menus: Powertrain / Engine and ECT / Data List.
for 2WW:
Read the Data List according to the display on the GTS.
| Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| ASL Switch | Speed limiter switch signal | ON or OFF | ON: Speed limiter switch on OFF: Speed limiter switch off |
- |
| Vehicle Speed Used for CCS and ASL Computation | Vehicle speed | Min.: 0 km/h (0 mph), Max.: 255 km/h (159 mph) | Actual vehicle speed displayed | - |
| Speed Limit Stored by ASL | Vehicle speed | Min.: 0 km/h (0 mph), Max.: 255 km/h (159 mph) | Vehicle speed stored in memory | - |
| Accelerator Pedal Angle for Speed Limiter | Accelerator pedal angle | Min.: 0 %, Max.: 100 % | Accelerator pedal angle displayed | - |
| ASL Main SW | Speed limiter switch signal | ON or OFF | ON: Speed limiter switch on OFF: Speed limiter switch off |
- |
for 3ZR-FAE:
Enter the following menus: Powertrain / Cruise Control / Data List.
for 3ZR-FAE:
Read the Data List according to the display on the GTS.
| Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| ASL Vehicle Speed | Vehicle speed | Min.: 0 km/h (0 mph), Max.: 255 km/h (159 mph) | Actual vehicle speed displayed | - |
| ASL Memory Vehicle Speed | Vehicle speed | Min.: 0 km/h (0 mph), Max.: 255 km/h (159 mph) | Vehicle speed stored in memory | - |
| ASL Throttle Position | Throttle opening angle | Min.: 0 deg., Max.: 124.5 deg | Required throttle opening angle | - |
| ASL Ready | Speed limit standby condition | ON or OFF | ON: Speed limiter switch on OFF: Speed limiter switch off |
- |
| ASL Main Switch | Speed limiter switch signal | ON or OFF | ON: Speed limiter switch on OFF: Speed limiter switch off |
- |
| ASL Shift Position Request | Transaxle gear request signal | Min.: 1, Max.: 8 | Required transaxle gear | for CVT |
ACTIVE TEST
Tech Tips
Using the GTS to perform Active Tests allows relays, VSVs, actuators and other item to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Body Electrical / Combination Meter / Active Test.
Perform "Active Test" according to the display on GTS.
| Tester Display | Measurement Item | Control Range | Diagnostic Note |
|---|---|---|---|
| Meter Display 1 | Multi-information display | OFF or All | - |