| DTC Code | DTC Name |
|---|---|
| P0500 | Vehicle Speed Sensor Malfunction |
DESCRIPTION
The speed sensor detects the wheel speed and sends the appropriate signals to the brake actuator assembly (skid control ECU). The brake actuator assembly (skid control ECU) converts these wheel speed signals into a 4-pulse signal and outputs it to the ECM via the combination meter assembly. The ECM determines the vehicle speed based on the frequency of this pulse signal.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| P0500 | Vehicle Speed Sensor Malfunction | The vehicle speed signal from the vehicle speed sensor is cut for 0.14 seconds or more while the cruise control is in operation. |
|
CAUTION / NOTICE / HINT
This DTC may be stored under the SFI system or ECD system at the same time. In that case, perform troubleshooting for the SFI system or ECD system first.
PROCEDURE
CHECK FOR DTC
Clear the DTCs.
Perform the following to make sure the DTC detection conditions are met.
Tech Tips
If the detection conditions are not met, the system cannot detect the malfunction.
Drive the vehicle for more than 10 seconds when the engine coolant temperature is more than 20°C (68°F).
Check for DTCs.
| Result | ||||
|---|---|---|---|---|
|
| DTC P0500 is not output |
|
USE SIMULATION METHOD TO CHECK Click here |
| DTC P0500 is output (for SFI System) |
|
GO TO SFI SYSTEM for 2AR-FE (w/ Canister Pump Module): Click here |
| DTC P0500 is output (for ECD System) |
|
GO TO ECD SYSTEM for 1AD-FTV: Click here |