STARTER REMOVAL

PROCEDURE


  1. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.

    Click here

  2. DISCONNECT CABLE FROM BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  3. REMOVE NO. 1 ENGINE COVER

    Click here

  4. REMOVE NO. 1 ENGINE UNDER COVER

    Click here

  5. DISCONNECT CABLE FROM POSITIVE BATTERY TERMINAL

  6. REMOVE BATTERY CLAMP SUB-ASSEMBLY

    Click here

  7. REMOVE BATTERY INSULATOR

  8. REMOVE BATTERY

  9. REMOVE BATTERY TRAY

  10. REMOVE BATTERY CARRIER

    Click here

  11. REMOVE BATTERY BRACKET REINFORCEMENT

    Click here

  12. DISCONNECT NO. 1 VACUUM PIPE


    1. A01V8Z2

      Using an E7 "TORX" socket wrench, remove the bolt and disconnect the No. 1 vacuum pipe from the cylinder block sub-assembly.

    2. Remove the O-ring from the No. 1 vacuum pipe.

  13. REMOVE ENGINE OIL LEVEL DIPSTICK GUIDE


    1. A01V8ER

      Disengage the 6 clamps and disconnect the No. 2 engine wire from the engine oil level dipstick guide.

    2. Remove the engine oil level dipstick.

    3. A01V6QC

      Disengage the clamp and disconnect the fuel feed pipe sub-assembly from the engine oil level dipstick guide.

    4. Using a T25 "TORX" socket wrench, remove the bolt and engine oil level dipstick guide.

    5. Remove the O-ring from the engine oil level dipstick guide.

  14. REMOVE STARTER ASSEMBLY


    1. A01VAML

      Open the terminal cap.

    2. Remove the nut and disconnect the No. 2 engine wire from the starter assembly.

    3. Remove the nut and disconnect the engine wire from the starter assembly.

    4. A01VAWI

      Using an E14 "TORX" socket wrench, remove the 2 bolts and starter assembly.