GLOW PLUG CONTROLLER INSTALLATION

PROCEDURE

1. INSTALL GLOW PLUG CONTROLLER ASSEMBLY

   
   
   1. 

      *1	Guide
      	Install in this Direction

      Using a T25 "TORX" socket wrench, install the glow plug controller assembly with the bolt as shown in the illustration.

      Torque:

      8.0 N*m  { 82 kgf*cm, 71 in.*lbf }

   2. Connect the 2 glow plug controller assembly connectors.

2. INSTALL NO. 1 ENGINE COVER

   Click here

3. CONNECT CABLE TO BATTERY TERMINAL

   Note

   When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

   Click here