STARTER(w/ Stop And Start System) DISASSEMBLY

PROCEDURE


  1. REMOVE STARTER INRUSH CURRENT REDUCTION RELAY (for CVT)


    1. A01QQ3F

      Remove the 2 nuts and wire harness from the starter assembly.

    2. A01QPBH

      Remove the 2 harness connectors to remove the harness from the starter assembly.

    3. A01QSBT

      Remove the nut and disconnect the lead wire from the terminal M.

    4. Remove the 2 bolts and starter inrush current reduction relay.

  2. REMOVE REPAIR SERVICE STARTER KIT (for CVT)


    1. A01QSGQ

      Holding the repair service starter kit to the starter drive housing assembly, remove the 2 nuts.

    2. A01QS23C05
      *1 Pinion Drive Lever
      *2 Plunger
      *a Hook

      While lifting the front of the repair service starter kit, remove the hook from the pinion drive lever, then remove the repair service starter kit.

      Note

      Do not drop the plunger when removing the repair service starter kit.

  3. REMOVE MAGNET STARTER SWITCH ASSEMBLY (for Manual Transaxle)


    1. A01QOGO

      Remove the nut and disconnect the lead wire from terminal C.

    2. A01QS6H

      Remove the 2 nuts holding the magnet starter switch assembly to the starter drive housing assembly.

    3. Remove the magnet starter switch assembly.

  4. REMOVE STARTER YOKE ASSEMBLY


    1. A01QRAI

      Using a T25 "TORX" socket wrench, remove the 2 bolts.

    2. A01QOT7

      Remove the starter yoke assembly together with the starter commutator end frame assembly from the starter drive housing assembly.

  5. REMOVE STARTER COMMUTATOR END FRAME ASSEMBLY


    1. A01QTWJ

      Remove the 2 screws.

    2. A01QTPQ

      Remove the starter commutator end frame assembly from the starter yoke assembly.

      Note

      while holding down the lead wire, remove the starter commutator end frame assembly.

  6. REMOVE STARTER BRUSH HOLDER ASSEMBLY


    1. A01QOVLC06
      *a Spring
      *b Brush

      Using a screwdriver, hold the spring back and disconnect the 4 brushes.

    2. Remove the starter brush holder assembly.

  7. REMOVE STARTER ARMATURE ASSEMBLY


    1. A01QPYV

      Remove the starter armature assembly from the starter yoke assembly.

  8. REMOVE STARTER ARMATURE PLATE


    1. A01QUNQC04
      *1 Starter Drive Housing Assembly
      *2 Starter Yoke Assembly
      *3 Starter Armature Plate

      Remove the starter armature plate from the starter drive housing assembly or starter yoke assembly.

  9. REMOVE PLANETARY GEAR


    1. A01QSCX

      Remove the 3 planetary gears from the starter center bearing clutch sub-assembly.

  10. REMOVE STARTER CENTER BEARING CLUTCH SUB-ASSEMBLY


    1. A01QSBRC04
      *1 Rubber Seal
      *2 Pinion Drive Lever
      *3 Starter Center Bearing Clutch Sub-assembly

      Remove the starter center bearing clutch sub-assembly together with the pinion drive lever and rubber seal from the starter drive housing assembly.

    2. Remove the pinion drive lever and rubber seal from the starter center bearing clutch sub-assembly.