STARTER(for 1.7 kW Type) DISASSEMBLY

PROCEDURE


  1. REMOVE MAGNET STARTER SWITCH ASSEMBLY


    1. B002AOE

      Remove the nut and disconnect the lead wire from terminal C.

    2. B002ABH

      Remove the 2 nuts holding the magnet starter switch assembly to the starter drive housing assembly.

    3. Remove the magnet starter switch assembly.

  2. REMOVE STARTER YOKE ASSEMBLY


    1. B0029OH

      Remove the 2 through-bolts and pull out the starter yoke assembly together with the starter commutator end frame assembly.

    2. B0029JQ

      Remove the starter yoke assembly from the starter commutator end frame assembly.

  3. REMOVE STARTER ARMATURE PLATE


    1. B002AGN

      Remove the starter armature plate from the starter yoke assembly.

  4. REMOVE STARTER COMMUTATOR END FRAME COVER


    1. B0029NN

      Using a screwdriver, pry out the starter commutator end frame cover to remove it.

  5. REMOVE STARTER ARMATURE ASSEMBLY


    1. B002A05C07
      *a Snap Ring Pliers

      Using snap ring pliers, remove the snap ring and washer.

    2. Remove the starter armature assembly from the starter commutator end frame assembly.

      Note

      Do not drop the starter armature assembly.

  6. REMOVE RUBBER SEAL


    1. B002A9Q

      Remove the rubber seal from the repair service starter kit.

  7. REMOVE PLANETARY GEAR


    1. B0029EV

      Remove the 3 planetary gears from the repair service starter kit.