RELAY ON-VEHICLE INSPECTION

PROCEDURE


  1. INSPECT STARTER RELAY (ST)


    1. A00YXNAC01

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      3 - 5 Battery voltage not applied to terminals 1 and 2 10 kΩ or higher
      Battery voltage applied to terminals 1 and 2 Below 1 Ω

      If the result is not as specified, replace the starter relay.

  2. INSPECT GLOW PLUG RELAY


    1. A00YS45

      Disconnect the glow plug relay connector.

    2. Detach the clamp and remove the glow plug relay.

    3. A00YR7MC01

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      1 - 2 Battery voltage not applied to terminals 3 and 4 10 kΩ or higher
      Battery voltage applied to terminals 3 and 4 Below 1 Ω

      If the result is not as specified, replace the glow plug relay.