ENGINE OIL COOLER INSTALLATION
CAUTION / NOTICE / HINT
Note
-
When replacing the injectors (including shuffling the injectors between the cylinders), common rail, intake manifold or cylinder head, it is necessary to replace the injection pipes with new ones.
-
When replacing the fuel supply pump, common rail, intake manifold or cylinder head, it is necessary to replace the fuel inlet pipe with a new one.
PROCEDURE
-
INSTALL OIL COOLER ASSEMBLY
-
Apply engine oil to the 2 new gaskets labeled B in the illustration.
Note
Do not apply engine oil to the new gasket labeled A in the illustration.
-
Install the 3 new gaskets to the No. 1 oil cooler bracket.
-
Install the oil cooler assembly with the 5 bolts.
- Torque:
- 10 N*m { 102 kgf*cm, 7 ft.*lbf }
-
-
INSTALL WATER BY-PASS HOSE
-
*1 Paint Mark *a Upper Side Install the water by-pass hose to the water outlet and oil cooler assembly, and slide the 2 clamps to secure the hose.
Tech Tips
Make sure the claws of hose clamp A are positioned above the paint mark as shown in the illustration.
-
-
INSTALL INTAKE MANIFOLD
-
CONNECT NO. 2 VACUUM TRANSMITTING HOSE ASSEMBLY
-
INSTALL NO. 2 INTAKE MANIFOLD
-
INSTALL ENGINE COVER BRACKET
-
INSTALL GAS FILTER BRACKET
-
INSTALL NO. 1 GAS FILTER
-
INSTALL DIESEL TURBO PRESSURE SENSOR
-
INSTALL ENGINE OIL LEVEL DIPSTICK GUIDE
-
INSTALL INTAKE MANIFOLD INSULATOR
-
INSTALL COMMON RAIL ASSEMBLY
-
INSTALL INJECTION PIPE SUB-ASSEMBLY
-
INSTALL FUEL INLET PIPE SUB-ASSEMBLY
-
INSTALL ELECTRIC EGR CONTROL VALVE ASSEMBLY
-
INSTALL NO. 2 EGR PIPE SUB-ASSEMBLY
-
CONNECT NO. 8 WATER BY-PASS HOSE
-
INSTALL NO. 7 WATER BY-PASS HOSE
-
INSTALL EGR VALVE BRACKET
-
CONNECT ENGINE WIRE
-
INSTALL DIESEL THROTTLE BODY ASSEMBLY
-
ADD ENGINE OIL
-
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
Note
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
-
ADD ENGINE COOLANT
-
BLEED AIR FROM FUEL SYSTEM
-
INSPECT FOR COOLANT LEAK
-
INSPECT FOR OIL LEAK
-
INSPECT FOR FUEL LEAK
-
INSPECT ENGINE OIL LEVEL