EXHAUST GAS TEMPERATURE SENSOR(for Sensor 2) INSTALLATION

PROCEDURE


  1. INSTALL EXHAUST GAS TEMPERATURE SENSOR (for Sensor 2)


    1. A01V95XC01
      *a Torque Wrench Fulcrum Length

      Using a 14 mm union nut wrench, install the exhaust gas temperature sensor.

      Torque:
      Specified tightening torque
      30 N*m  { 306 kgf*cm, 22 ft.*lbf }

      Note

      If the exhaust gas temperature sensor is dropped, replace it with a new one.

      Tech Tips


      • Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.

        Click here

      • When using a 14 mm union nut wrench (fulcrum length of 25 mm (0.984 in.)) + torque wrench (fulcrum length of 300 mm (11.8 in.)): 28 N*m (286 kgf*cm, 21 ft.*lbf)

    2. Pass the wire harness through the hook on the cylinder head cover side.

    3. Attach the wire harness clamp.

    4. Connect the exhaust gas temperature sensor connector.

  2. INSPECT FOR EXHAUST GAS LEAK

    Click here

  3. INSTALL NO. 1 ENGINE COVER

    Click here