DIFFERENTIAL PRESSURE SENSOR ON-VEHICLE INSPECTION

PROCEDURE


  1. CHECK DIFFERENTIAL PRESSURE SENSOR ASSEMBLY


    1. Connect the GTS to the DLC3.

    2. Turn the ignition switch to ON.

    3. Turn the GTS on.

    4. Enter the following menus: Powertrain / Engine / Data List / DPF Differential Pressure.


      Powertrain > Engine > Data List
      Tester Display
      DPF Differential Pressure

    5. Slide the clamp and disconnect the vacuum transmitting hose assembly from the differential pressure sensor assembly.

    6. A00YTX1C01
      *a Pressure

      Using SST, apply pressure to the differential pressure sensor assembly.

      SST
      09992-00242

    7. Check the pressure value of the differential pressure sensor assembly.

      Standard pressure
      Approximately the same pressure as the applied pressure is indicated on the GTS.

      Note

      Perform the inspection within the range of 0 to 98 kPa (0 to 1.0 kgf/cm2, 0 to 14.2 psi).

      If the result is not as specified, check the differential pressure sensor circuit.

      Click here

    8. Connect the vacuum transmitting hose assembly to the differential pressure sensor assembly, and slide the clamp to secure the hose.