ENGINE UNIT COMPONENTS
ILLUSTRATION
| *1 | AIR TUBE | *2 | FUEL DELIVERY PIPE SUB-ASSEMBLY |
| *3 | FUEL INJECTOR ASSEMBLY | *4 | FUEL TUBE SUB-ASSEMBLY |
| *5 | INTAKE MANIFOLD | *6 | THROTTLE BODY ASSEMBLY |
| *7 | WIRE HARNESS CLAMP BRACKET | *8 | INTAKE MANIFOLD STAY |
| *9 | GASKET | *10 | NO. 1 DELIVERY PIPE SPACER |
| *11 | O-RING | *12 | INJECTOR VIBRATION INSULATOR |
| *13 | NO. 2 FUEL PIPE CLAMP | - | - |
| *a | for Type A | *b | for Type B |
 |
N*m (kgf*cm, ft.*lbf): Specified torque | ● | Non-reusable part |
ILLUSTRATION
| *1 | EXHAUST MANIFOLD | *2 | MANIFOLD STAY |
| *3 | NO. 1 EXHAUST MANIFOLD HEAT INSULATOR | *4 | EXHAUST MANIFOLD GASKET |
| |
N*m (kgf*cm, ft.*lbf): Specified torque | ● | Non-reusable part |
ILLUSTRATION
| *1 | UNION TO CHECK VALVE HOSE | *2 | VACUUM PUMP ASSEMBLY |
| *3 | NO. 2 O-RING | *4 | NO. 3 O-RING |
| |
N*m (kgf*cm, ft.*lbf): Specified torque | ● | Non-reusable part |
 |
Engine Oil | - | - |
ILLUSTRATION
| *A | for Manual Transaxle | *B | for CVT |
| *1 | ENGINE OIL LEVEL DIPSTICK GUIDE | *2 | HEATER WATER INLET HOSE |
| *3 | HEATER WATER OUTLET HOSE | *4 | IGNITION COIL ASSEMBLY |
| *5 | NO. 1 SEAL PLATE | *6 | NO. 1 VACUUM PUMP BRACKET |
| *7 | NO. 1 WATER BY-PASS PIPE | *8 | NO. 3 WATER BY-PASS HOSE |
| *9 | NO. 3 WATER BY-PASS PIPE | *10 | PCV HOSE |
| *11 | V-RIBBED BELT TENSIONER ASSEMBLY | *12 | WATER BY-PASS HOSE |
| *13 | WATER INLET HOSE | *14 | GASKET |
| *15 | O-RING | *16 | ENGINE OIL LEVEL DIPSTICK |
| |
N*m (kgf*cm, ft.*lbf): Specified torque | ● | Non-reusable part |
ILLUSTRATION
| *1 | CAMSHAFT POSITION SENSOR | *2 | CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY |
| *3 | CYLINDER HEAD COVER GASKET | *4 | CYLINDER HEAD COVER SUB-ASSEMBLY |
| *5 | ENGINE COVER JOINT | *6 | OIL FILLER CAP GASKET |
| *7 | OIL FILLER CAP SUB-ASSEMBLY | *8 | SPARK PLUG |
| *9 | SPARK PLUG TUBE GASKET | *10 | SEAL WASHER |
| *11 | O-RING | *12 | BRACKET |
| *13 | GASKET | - | - |
| |
N*m (kgf*cm, ft.*lbf): Specified torque | ● | Non-reusable part |
ILLUSTRATION
| *1 | CRANKSHAFT PULLEY | *2 | ENGINE MOUNTING BRACKET STUD BOLT |
| *3 | ENGINE OIL PRESSURE SWITCH ASSEMBLY | *4 | ENGINE OIL TEMPERATURE SENSOR |
| *5 | NO. 1 CHAIN TENSIONER ASSEMBLY | *6 | OIL FILTER SUB-ASSEMBLY |
| *7 | THERMOSTAT | *8 | TIMING CHAIN COVER OIL SEAL |
| *9 | TIMING CHAIN COVER SUB-ASSEMBLY | *10 | UNION |
| *11 | WATER INLET | *12 | WATER INLET HOUSING |
| *13 | GASKET | *14 | BRACKET |
| *15 | OIL FILTER BRACKET | *16 | O-RING |
| *17 | SEAL WASHER | *18 | ENGINE WATER PUMP ASSEMBLY |
| *19 | ENGINE MOUNTING BRACKET RH | - | - |
| |
N*m (kgf*cm, ft.*lbf): Specified torque | ● | Non-reusable part |
| ★ | Precoated part |  |
Do not apply lubricants to the threads |
| |
MP grease | - | - |
ILLUSTRATION
| *1 | CHAIN SUB-ASSEMBLY | *2 | CHAIN TENSIONER SLIPPER |
| *3 | CRANKSHAFT POSITION SENSOR | *4 | CRANKSHAFT TIMING GEAR KEY |
| *5 | CRANKSHAFT TIMING SPROCKET | *6 | NO. 1 CHAIN VIBRATION DAMPER |
| *7 | NO. 1 CRANKSHAFT POSITION SENSOR PLATE | *8 | NO. 2 CHAIN SUB-ASSEMBLY |
| *9 | O-RING | *10 | OIL PUMP DRIVE GEAR |
| *11 | OIL PUMP DRIVE SHAFT GEAR | *12 | CHAIN DAMPER SPRING |
| *13 | CHAIN TENSIONER PLATE | - | - |
| |
N*m (kgf*cm, ft.*lbf): Specified torque | ● | Non-reusable part |
ILLUSTRATION
| *1 | CAMSHAFT HOUSING SUB-ASSEMBLY | *2 | CAMSHAFT TIMING EXHAUST GEAR ASSEMBLY |
| *3 | CAMSHAFT TIMING GEAR ASSEMBLY | *4 | CONTINUOUSLY VARIABLE VALVE LIFT CONTROLLER ASSEMBLY |
| *5 | CYLINDER HEAD GASKET | *6 | CYLINDER HEAD SUB-ASSEMBLY |
| *7 | ENGINE COOLANT TEMPERATURE SENSOR | *8 | NO. 1 VALVE ROCKER ARM SUB-ASSEMBLY |
| *9 | VALVE LASH ADJUSTER ASSEMBLY | *10 | VALVE ROCKER ARM LOST MOTION DAMPER SUB-ASSEMBLY |
| *11 | VALVE STEM CAP | *12 | VALVE LIFT CONTROL ACTUATOR CONNECTOR |
| *13 | VALVE LIFT CONTROL ACTUATOR CLIP | *14 | STRAIGHT PIN |
| *15 | O-RING | *16 | WIRE HARNESS CLAMP BRACKET |
| *17 | PLATE WASHER | *18 | GASKET |
| |
N*m (kgf*cm, ft.*lbf): Specified torque | ● | Non-reusable part |
| *T1 | 1st: 49 (500, 36) 2nd: Turn 90° 3rd: Turn 45° |
- | - |
ILLUSTRATION
| *1 | ENGINE REAR OIL SEAL | *2 | KNOCK SENSOR |
| *3 | NO. 1 GENERATOR BRACKET | *4 | NO. 1 TAPER SCREW PLUG |
| *5 | NO. 2 OIL PAN SUB-ASSEMBLY | *6 | OIL PAN DRAIN PLUG |
| *7 | OIL PUMP ASSEMBLY | *8 | STIFFENING CRANKCASE ASSEMBLY |
| *9 | STIFFENING CRANKCASE RING PIN | *10 | PCV VALVE SUB-ASSEMBLY |
| *11 | GASKET | - | - |
| |
N*m (kgf*cm, ft.*lbf): Specified torque | ● | Non-reusable part |
| |
MP grease | ★ | Precoated part |