CYLINDER HEAD GASKET REMOVAL

PROCEDURE


  1. REMOVE CAMSHAFT HOUSING SUB-ASSEMBLY

    Click here

  2. REMOVE EXHAUST MANIFOLD

    Click here

  3. DISCONNECT NO. 1 WATER BY-PASS PIPE


    1. B0029BE

      Remove the 2 bolts and disconnect the No. 1 water by-pass pipe from the cylinder head sub-assembly.

  4. REMOVE VALVE STEM CAP

    Click here

  5. REMOVE CYLINDER HEAD SUB-ASSEMBLY


    1. B0029ADE01

      Using a 10 mm bi-hexagon wrench, uniformly loosen and remove the 10 cylinder head bolts and 10 plate washers in several steps in the sequence shown in the illustration.

      Note


      • Be careful not to drop washers into the cylinder head sub-assembly.

      • Head warpage or cracking could result from removing the bolts in the wrong order.

    2. Using a screwdriver with its tip wrapped with tape, pry between the cylinder head sub-assembly and cylinder block assembly, and remove the cylinder head sub-assembly.

      Note

      Be careful not to damage the contact surfaces of the cylinder head sub-assembly and cylinder block assembly.

  6. REMOVE CYLINDER HEAD GASKET


    1. B0029YS

      Remove the cylinder head gasket.

  7. INSPECT CYLINDER HEAD FOR FLATNESS

    Click here

  8. INSPECT CYLINDER HEAD BOLT

    Click here