ENGINE ASSEMBLY COMPONENTS
ILLUSTRATION
| *1 | DIFFERENTIAL PRESSURE SENSOR ASSEMBLY | *2 | FRONT FLOOR COVER |
| *3 | FRONT FLOOR COVER RH | *4 | NO. 1 ENGINE COVER |
| *5 | NO. 1 ENGINE UNDER COVER | *6 | REAR ENGINE UNDER COVER LH |
| *7 | REAR ENGINE UNDER COVER RH | *8 | VACUUM TRANSMITTING HOSE |
 |
Specified torque: N*m (kgf*cm, ft.*lbf) | - | - |
ILLUSTRATION
| *A | for DPF | - | - |
| *1 | FRONT EXHAUST PIPE ASSEMBLY | *2 | PROPELLER SHAFT WITH CENTER BEARING ASSEMBLY |
| *3 | AIR FUEL RATIO SENSOR | *4 | WIRE HARNESS CLAMP |
| *5 | TAILPIPE ASSEMBLY | *6 | COMPRESSION SPRING |
| *7 | GASKET | - | - |
| |
Specified torque: N*m (kgf*cm, ft.*lbf) | * | For use with SST |
| ● | Non-reusable part |  |
Do not apply lubricants |
ILLUSTRATION
| *1 | AIR CLEANER CAP SUB-ASSEMBLY | *2 | AIR CLEANER CASE |
| *3 | AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY | *4 | BATTERY |
| *5 | BATTERY BRACKET REINFORCEMENT | *6 | BATTERY CLAMP SUB-ASSEMBLY |
| *7 | BATTERY INSULATOR | *8 | BATTERY TRAY |
| *9 | NEGATIVE BATTERY TERMINAL | *10 | POSITIVE BATTERY TERMINAL |
| *11 | FRONT BATTERY BRACKET | - | - |
| |
Specified torque: N*m (kgf*cm, ft.*lbf) | - | - |
ILLUSTRATION
| *A | for Manual Transaxle | - | - |
| *1 | AIR CLEANER BRACKET | *2 | AIR CLEANER SUPPORT |
| *3 | DISCHARGE HOSE SUB-ASSEMBLY | *4 | NO. 2 RADIATOR HOSE |
| *5 | NO. 3 AIR HOSE | *6 | SUCTION HOSE SUB-ASSEMBLY |
| *7 | FUEL FILTER ASSEMBLY | *8 | TRANSMISSION CONTROL CABLE ASSEMBLY |
| *9 | INLET HEATER WATER HOSE | *10 | OUTLET HEATER WATER HOSE |
| *11 | FUEL HOSE PROTECTOR | *12 | NO. 2 WATER BY-PASS HOSE |
| *13 | PIN | *14 | O-RING |
| |
Specified torque: N*m (kgf*cm, ft.*lbf) | ● | Non-reusable part |
 |
Compressor oil ND-OIL 8 or equivalent | - | - |
ILLUSTRATION
| *1 | ECM | *2 | NO. 2 VACUUM TRANSMITTING HOSE ASSEMBLY |
| *3 | RADIATOR HOSE SUB-ASSEMBLY | *4 | RADIATOR RESERVOIR ASSEMBLY |
| *5 | ENGINE ROOM RELAY BLOCK AND JUNCTION BLOCK COVER | *6 | INJECTOR DRIVER ASSEMBLY |
| |
Specified torque: N*m (kgf*cm, ft.*lbf) | - | - |
ILLUSTRATION
| *1 | COLUMN HOLE COVER SILENCER SHEET | *2 | FRONT AXLE SHAFT NUT LH |
| *3 | FRONT STABILIZER LINK ASSEMBLY LH | *4 | NO. 2 STEERING INTERMEDIATE SHAFT |
| *5 | FRONT SPEED SENSOR LH | *6 | TIE ROD END SUB-ASSEMBLY LH |
| *7 | FRONT SUSPENSION NO. 1 LOWER ARM SUB-ASSEMBLY LH | *8 | FRONT DRIVE SHAFT ASSEMBLY RH |
| *9 | FRONT DRIVE SHAFT ASSEMBLY LH | *10 | FRONT DRIVE SHAFT HOLE SNAP RING LH |
| |
Specified torque: N*m (kgf*cm, ft.*lbf) | ● | Non-reusable part |
| |
MP grease | |
Do not apply lubricants to the threads |
ILLUSTRATION
| *A | for Automatic Transaxle | - | - |
| *1 | ENGINE MOUNTING BRACKET LH | *2 | FRONT SUSPENSION MEMBER REINFORCEMENT LH |
| *3 | FRONT SUSPENSION MEMBER REINFORCEMENT RH | *4 | FRONT ENGINE MOUNTING INSULATOR |
| *5 | REAR ENGINE MOUNTING INSULATOR | *6 | FRONT SUSPENSION MEMBER REAR BRACE RH |
| *7 | FRONT SUSPENSION MEMBER REAR BRACE LH | *8 | FRONT SUSPENSION MEMBER SUB-ASSEMBLY |
| *9 | FRONT CROSSMEMBER SUB-ASSEMBLY | *10 | NO. 1 ENGINE HANGER |
| *11 | NO. 2 ENGINE HANGER | - | - |
| |
Specified torque: N*m (kgf*cm, ft.*lbf) | ★ | Precoated part |
ILLUSTRATION
| *A | for Manual Transaxle | - | - |
| *1 | CLUTCH COVER ASSEMBLY | *2 | CLUTCH DISC ASSEMBLY |
| *3 | CLUTCH RELEASE CYLINDER ASSEMBLY | *4 | FLYWHEEL WITH DAMPER ASSEMBLY |
| *5 | FRONT ENGINE MOUNTING BRACKET | *6 | INTERCOOLER AIR HOSE |
| *7 | MANUAL TRANSAXLE ASSEMBLY | *8 | NO. 1 AIR TUBE |
| *9 | OIL PAN INSULATOR | *10 | REAR ENGINE MOUNTING INSULATOR |
| *11 | STARTER ASSEMBLY | *12 | STIFFENER PLATE LH |
| *13 | STIFFENER PLATE RH | - | - |
| |
Specified torque: N*m (kgf*cm, ft.*lbf) | ● | Non-reusable part |
ILLUSTRATION
| *A | for Automatic Transaxle | - | - |
| *1 | AUTOMATIC TRANSAXLE ASSEMBLY | *2 | DRIVE PLATE AND RING GEAR SUB-ASSEMBLY |
| *3 | FRONT ENGINE MOUNTING BRACKET | *4 | INTERCOOLER AIR HOSE |
| *5 | NO. 1 AIR TUBE | *6 | OIL PAN INSULATOR |
| *7 | REAR ENGINE MOUNTING BRACKET | *8 | STARTER ASSEMBLY |
| *9 | STIFFENER PLATE LH | *10 | STIFFENER PLATE RH |
| *11 | FRONT DRIVE PLATE SPACER | *12 | REAR DRIVE PLATE SPACER |
| *13 | TRANSMISSION CONTROL CABLE ASSEMBLY | - | - |
| *a | BLACK: x 1 SILVER: x 5 |
- | - |
| |
Specified torque: N*m (kgf*cm, ft.*lbf) | ● | Non-reusable part |
| ★ | Precoated part | - | - |
ILLUSTRATION
| *A | for Automatic Transaxle | - | - |
| *1 | ENGINE MOUNTING INSULATOR LH | *2 | ENGINE MOUNTING INSULATOR SUB-ASSEMBLY RH |
| |
Specified torque: N*m (kgf*cm, ft.*lbf) | - | - |