REAR CRANKSHAFT OIL SEAL INSTALLATION

PROCEDURE


  1. INSTALL REAR ENGINE OIL SEAL


    1. Apply MP grease to the lip of a new rear engine oil seal.

    2. A01VB36N01

      Using SST and a hammer, tap in the rear engine oil seal as shown in the illustration.

      SST
      09223-56010
      Standard depth
      0 to 0.9 mm (0 to 0.0354 in.)

      Note


      • Keep the lip free from foreign matter.

      • Do not tap the rear engine oil seal at an angle.

      • Make sure that the rear engine oil seal is properly installed.

  2. INSTALL FLYWHEEL WITH DAMPER ASSEMBLY (for Manual Transaxle)

    Click here

  3. INSTALL DRIVE PLATE AND RING GEAR SUB-ASSEMBLY (for Automatic Transaxle)

    Click here

  4. INSTALL CLUTCH DISC ASSEMBLY (for Manual Transaxle)

    Click here

  5. INSTALL CLUTCH COVER ASSEMBLY (for Manual Transaxle)

    Click here

  6. INSPECT AND ADJUST CLUTCH COVER ASSEMBLY (for Manual Transaxle)

    Click here

  7. INSTALL MANUAL TRANSAXLE ASSEMBLY (for Manual Transaxle)

    Click here

  8. INSTALL AUTOMATIC TRANSAXLE ASSEMBLY (for Automatic Transaxle)

    Click here

  9. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here