HEATED OXYGEN SENSOR INSTALLATION

PROCEDURE


  1. INSTALL HEATED OXYGEN SENSOR (for Bank 1 Sensor 2)


    1. A01V9CDC01
      *1 Fulcrum Length

      Using SST, install the heated oxygen sensor to the center exhaust pipe assembly.

      SST
      09224-00010
      Torque:
      without SST
      44 N*m  { 449 kgf*cm, 32 ft.*lbf }
      with SST
      40 N*m  { 408 kgf*cm, 30 ft.*lbf }

      Tech Tips


      • Use a torque wrench with a fulcrum length of 30 cm (11.8 in.). When using a torque wrench with a fulcrum length that is not 30 cm (11.8 in.), calculate the torque specification for the torque wrench and SST based on the "without SST" torque specification.

        Click here

      • Make sure SST and the wrench are connected in a straight line.

      Note

      Do not damage the heated oxygen sensor.

    2. Pass the heated oxygen sensor connector through the floor panel and install the grommet.

    3. Connect the heated oxygen sensor connector.

  2. INSTALL REAR CONSOLE BOX SUB-ASSEMBLY

    Click here

  3. INSPECT FOR EXHAUST GAS LEAK

    Click here