SFI SYSTEM(for K111, K111F), Diagnostic DTC:P0630

DTC Code DTC Name
P0630 VIN not Programmed or Mismatch - ECM / PCM

DESCRIPTION

DTC P0630 is stored when the Vehicle Identification Number (VIN) is not stored in the ECM or the input VIN is not accurate.

DTC No. Detection Item DTC Detection Condition Trouble Area MIL Memory
P0630 VIN not Programmed or Mismatch - ECM / PCM

When either of the following conditions is met (1 trip detection logic).


  • The VIN is not stored in the ECM.

  • The VIN input into the ECM is not accurate.

 ECM Comes on DTC stored

CONFIRMATION DRIVING PATTERN


  1. Connect the GTS to the DLC3.

  2. Turn the ignition switch to ON and turn the GTS on.

  3. Clear the DTCs (even if no DTCs are stored, perform the clear DTC procedure)

  4. Turn the ignition switch off and wait for at least 30 seconds.

  5. Turn the ignition switch to ON and turn the GTS on.

  6. Wait 5 seconds or more.

  7. Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.

  8. Read the pending DTCs.

    Tech Tips


    • If a pending DTC is output, the system is malfunctioning.

    • If a pending DTC is not output, perform the following procedure.

  9. Enter the following menus: Powertrain / Engine and ECT / Utility / All Readiness.

  10. Input the DTC: P0630.

  11. Check the DTC judgment result.

    GTS Display Description
    NORMAL

    • DTC judgment completed

    • System normal
    ABNORMAL

    • DTC judgment completed

    • System abnormal
    INCOMPLETE

    • DTC judgment not completed

    • Perform driving pattern after confirming DTC enabling conditions
    N/A

    • Unable to perform DTC judgment

    • Number of DTCs which do not fulfill DTC preconditions has reached ECU memory limit

    Tech Tips


    • If the judgment result shows NORMAL, the system is normal.

    • If the judgment result shows ABNORMAL, the system has a malfunction.

    • If the judgment result shows INCOMPLETE or N/A, perform the Confirmation Driving Pattern and check the DTC judgment result again.

PROCEDURE


  1. CHECK ANY OTHER DTCS OUTPUT (IN ADDITION TO DTC P0630)


    1. Connect the GTS to the DLC3.

    2. Turn the ignition switch to ON.

    3. Turn the GTS on.

    4. Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.

    5. Read the DTCs.


      Powertrain > Engine and ECT > Trouble Codes
      Result
      Result Proceed to
      DTC P0630 is output A
      DTC P0630 and other DTCs are output B

      If any DTCs other than P0630 are output, troubleshoot those DTCs first.

      Note

      If P0630 is stored, the VIN must be input to the ECM using the GTS. However, all DTCs are cleared automatically by the GTS when the VIN is input. If DTCs other than P0630 are output, troubleshoot them first.


    B

    GO TO DTC CHART Click here

    A

  2. INPUT VIN


    1. Input the VIN.

      Click here

      Result
      Proceed to
      NEXT

    NEXT

    END