REAR CRANKSHAFT OIL SEAL REMOVAL

PROCEDURE


  1. REMOVE MANUAL TRANSAXLE ASSEMBLY (for Manual Transaxle)


  2. REMOVE CONTINUOUSLY VARIABLE TRANSAXLE ASSEMBLY (for CVT)


  3. REMOVE CLUTCH COVER ASSEMBLY (for Manual Transaxle)

    Click here

  4. REMOVE CLUTCH DISC ASSEMBLY (for Manual Transaxle)

    Click here

  5. REMOVE FLYWHEEL SUB-ASSEMBLY (for Manual Transaxle)


    1. A01CXBTN08

      Using SST, hold the crankshaft.

      for 86 mm (3.39 in.) Bolt Pitch Type:

      SST
      09213-58014   ( 91551-80840 )
      09330-00021

      for 64 mm (2.52 in.) Bolt Pitch Type:

      SST
      09213-54015

      Tech Tips

      For the 64 mm (2.52 in.) bolt pitch type, the part number of the installationbolt for SST (crankshaft pulley holding tool) is 91551-00850 (quantity: 2).

    2. A01CWU7

      Remove the 8 bolts and flywheel sub-assembly.

  6. REMOVE DRIVE PLATE AND RING GEAR SUB-ASSEMBLY (for CVT)


    1. A01CXBTN08

      Using SST, hold the crankshaft.

      for 86 mm (3.39 in.) Bolt Pitch Type:

      SST
      09213-58014   ( 91551-80840 )
      09330-00021

      for 64 mm (2.52 in.) Bolt Pitch Type:

      SST
      09213-54015

      Tech Tips

      For the 64 mm (2.52 in.) bolt pitch type, the part number of the installationbolt for SST (crankshaft pulley holding tool) is 91551-00850 (quantity: 2).

    2. A01CW1J

      Remove the 8 bolts, the rear drive plate spacer, the drive plate and ring gear sub-assembly and the front drive plate spacer.

  7. REMOVE ENGINE REAR OIL SEAL


    1. A01CXDKC08
      *1 Cut Position
      *2 Protective Tape

      Using a knife, cut off the lip of the engine rear oil seal.

    2. Using a screwdriver with its tip wrapped with tape, pry out the engine rear oil seal.

      Note


      • Do not damage the surface of the oil seal press fit hole or the crankshaft.

      • After removing the engine rear oil seal, check the crankshaft for damage. If damaged, smooth the surface with 400-grit sandpaper.