FRONT CRANKSHAFT OIL SEAL INSTALLATION

PROCEDURE


  1. INSTALL TIMING CHAIN COVER OIL SEAL


    1. B0029L9E01

      Apply MP grease to the lip of a new oil seal.

      Note


      • Do not allow foreign matter to contact the lip of the oil seal.

      • Do not allow MP grease to contact the dust seal.

    2. Using SST and a hammer, tap in the oil seal until its surface is flush with the timing chain cover edge.

      SST
      09223-22010

      Note


      • Wipe off any extra grease from the crankshaft.

      • Do not tap in the oil seal at an angle.

  2. INSTALL CRANKSHAFT PULLEY


    1. B0029F0C03
      *a Hold
      B0029FL Turn

      Align the key groove of the crankshaft pulley with the pulley set key.

    2. Temporarily install the crankshaft pulley with the pulley bolt.

    3. Using SST, hold the crankshaft pulley in place and tighten the pulley bolt.

      SST
      09213-54015
      Torque:
      190 N*m  { 1937 kgf*cm, 140 ft.*lbf }

      Tech Tips

      Part number of installation bolt for SST (crankshaft pulley holding tool): 91551-00850 (quantity: 2).

  3. INSTALL V-RIBBED BELT

    Click here

  4. ADJUST V-RIBBED BELT

    Click here

  5. INSPECT V-RIBBED BELT

    Click here

  6. INSTALL FRONT SUSPENSION MEMBER REINFORCEMENT RH

    Click here

  7. INSPECT FOR OIL LEAK

    Click here

  8. INSPECT ENGINE OIL LEVEL

    Click here

  9. INSTALL REAR ENGINE UNDER COVER RH

    Click here

  10. INSTALL NO. 1 ENGINE UNDER COVER

    Click here

  11. INSTALL NO. 2 CYLINDER HEAD COVER

    Click here