FRONT CRANKSHAFT OIL SEAL REMOVAL

PROCEDURE


  1. REMOVE V-RIBBED BELT

    Click here

  2. REMOVE CRANKSHAFT PULLEY


    1. A01M0JE

      Remove the plug from the cylinder block.

    2. A01M2D5E01

      Set SST (A) to the plug hole of the cylinder block.

      SST (A)
      PZ4TB-04951-26
    3. A01LZW1C01
      *a Groove

      Using SST (B), turn the crankshaft pulley clockwise until SST (A) fits into the groove of the flywheel with damper assembly.

      SST (B)
      PZ4TB-04933-80

    4. Using SST (A), hold the flywheel with damper assembly.

    5. A01LVUD

      Using an E10 "TORX" socket wrench, remove the 4 bolts and crankshaft pulley.

  3. REMOVE TIMING GEAR CASE OR TIMING CHAIN CASE OIL SEAL


    1. A01LYMWC01
      *a Protective Tape

      Using a screwdriver, pry out the timing gear case or timing chain case oil seal.

      Note

      Do not damage the oil seal press fit hole, crankshaft or the surface of the timing gear case or timing chain case.

      Tech Tips

      Tape the screwdriver tip before use.