CRANKSHAFT POSITION SENSOR INSTALLATION

PROCEDURE

1. INSTALL CRANKSHAFT POSITION SENSOR

   
   

   1. Apply a light coat of engine oil to the O-ring of the crankshaft position sensor.

   2. Clean the bolt and bolt hole.

   3. Apply adhesive to 2 or 3 threads of the bolt.

      Adhesive
      Toyota Genuine Adhesive 1344, Three Bond 1344 or equivalent.

   4. Install the crankshaft position sensor with the bolt.

      Torque:

      10 N*m  { 102 kgf*cm, 7 ft.*lbf }

      Note

      
      

      • When reusing the crankshaft position sensor, inspect the O-ring.

      • Make sure that the O-ring is not cracked or jammed when installing the crankshaft position sensor.

   5. Connect the crankshaft position sensor connector.

2. INSPECT FOR OIL LEAK

   Click here

3. INSTALL REAR ENGINE UNDER COVER RH

   Click here