THROTTLE BODY INSPECTION

PROCEDURE


  1. INSPECT THROTTLE WITH MOTOR BODY ASSEMBLY

    A00YWRBC01
    *a

    Component without harness connected

    (Throttle with Motor Body Assembly)

    1. Check that the throttle valve opens and closes smoothly.

    2. Check that the there is no sludge accumulating around the throttle body.

    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      1 (M-) - 2 (M+) 20°C (68°F) 0.3 to 100 Ω

      If the result is not as specified, replace the throttle with motor body assembly.