THROTTLE BODY REMOVAL

PROCEDURE


  1. DRAIN ENGINE COOLANT

    Click here

  2. REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY


    1. A00YWDH

      Lift the rear of the No. 1 engine cover sub-assembly to detach the No. 1 engine cover sub-assembly from the 2 pins, and then lift the front of the No. 1 engine cover sub-assembly to detach the No. 1 engine cover sub-assembly from the pin and remove the No. 1 engine cover sub-assembly.

  3. REMOVE AIR CLEANER CAP SUB-ASSEMBLY

    Click here

  4. REMOVE THROTTLE WITH MOTOR BODY ASSEMBLY


    1. A00YXJA

      Slide the clamp and disconnect the No. 1 water by-pass hose from the throttle with motor body assembly.

    2. Slide the clamp and disconnect the No. 2 water by-pass hose from the throttle with motor body assembly.

    3. Remove the bolt and disconnect the fuel hose bracket.

      Note

      If the fuel hose is detached from the clamp shown in the illustration, the clamp cannot be reused.

    4. Disconnect the throttle with motor body assembly connector.

    5. A00YWC1

      Remove the 4 bolts and throttle with motor body assembly.

    6. A00YR9P

      Remove the gasket from the intake manifold.